SECTI BUN CORVAIR 11 in Page General Description 14 1 Front Bumper Assembly 14 1 Removal 14 1 Installation 14 1 GENERAL I The Corvair front and rear bumpers are of the onepiece design Each bumper is attached to the body by five mounting brackets at reinforced areas of the body l Fig 1 Front Bumper Attachment FRONT BUMPER ASSEMBLY See Fig 1 Removal 1 Open compartment lid and remove cover at each front corner of compartment 2 Remove three mounting bracket attaching bolts at each corner 3 Remove license plate 4 Remove two center mounting bracket bolts 5 Remove bumper from vehicle Installation 1 If installing new bumper transfer bumper brackets if undamaged to bumper before installation to body 2 Install attaching bolts for c e n t e r inner and outer brackets ON 14 IPERS D 000 SERIES IDEX Page Rear Bumper Assembly 14 1 Removal 14 1 Installation 14 1 ESCRIPTION 3 Tighten all bolts securely install license plate REAR BUMPER ASSEMBLY See Fig 2 Removal 1 From inside engine compartment remove inner and outer bracket attaching bolts three each side Remove spare tire to gain access to right hand bolts 2 Remove bolt attaching center bracket to body 3 Remove bumper from vehicle s y u w i a Fig 2 Rear Bumper Attachment Installation 1 If installing new bumper transfer brackets if undamaged to bumper before installation to body 2 Install attaching bolts for c e n t e r inner and outer brackets 3 Tighten bolts securely