CARTEI IIWDE Pagel General Description 6M 12 Service Procedures 6M 12 Accelerator Linkage Adjustment 6M 12 Idle Speed and Mixture Adjustment gM 12 Choke Adjustment gM 12 Additional Checks and Adjustments 6M 12 Fuel Filter Replacement gM 12 Repair Procedures gM 12 Removal gM 12 I GENERAL DE This section covers the Carter YH Carburetor used in SERVICE PR For Accelerator Linkage Adjustment Idle Speed and I Mixture Adjustment and Choke Adjustment refer to Section 6 Engine Tune Up Turbocharger Option Additional Checks and Adjustments The following checks and adjustments may be made without removing the carburetor from the vehicle Refer to Repair Procedures Assembly and Adjustments Metering Rod Adjustment Float Adjustments Fast Idle Adjustment Choke Unloader Adjustment Choke Adjustment Fuel Filter Replacement The fuel filter is a separate unit mounted on the air cleaner support bracket at the left of the air cleaner It should be replaced as recommended in Section 0 Replacement consists of disconnecting the inlet outlet and bypass fuel lines loosening clamp screw and re REPAIR PRO Removal With Turbocharger as an Assembly This method is outlined under Turbocharger Removal When this method is used caution is necessary to prevent damage to turbine wheel during disassembly of carburetor from Turbocharger Separately from Turbocharger 1 Remove air cleaner 2 Disconnect choke heat tube fuel line and accelerator linkage at carburetor 3 Remove carburetor mounting nuts and remove car buretor from vehicle NOTE It will be necessary to use a short or curved open end wrench to remove the front nut Disassembly 1 Remove inlet filter screen nut and screen 2 Remove six screws and float bowl cover fig 26 3 Remove float hinge pin float and float needle and seat 4 Remove float bowl cover gasket tip carburetor an remove pump discharge needle w w v OIL DRAIN CHOKE CLEAN CHOKE HEAT ts AIR TUBES PASSAGE tip r i 3