9 Carefully place bowl cover assembly and new gasket on bowl assembly and install the six screws and lock washers 10 Replace filter spring filter gasket gasket and inlet nut 11 Install pump rod in pump lever and retain with clip 12 Adjust Pump Rod as follows Fig Z4 Holding throttle valves closed check to see that the scribe mark on the accelerator pump lever is aligned with the raised cast tang front edge on the bowl cover The accelerator pump rod may be carefully bent using a carburetor rod bending tool such as Tool J 4552 to obtain the correct adjustment Installation 1 Install insulator block in place install carburetor on on intake manifold studs 2 Install two attaching nuts and washers and tighten evenly 3 Swing linkage bracket down and install attaching screws 4 Connect gas inlet line 5 Connect carburetor rod at carburetor throttle lever 6 Check carburetors for Carburetor Synchronization as outlined in Section 6 Engine Tune Up Corvair 10700 series canAe sHOr Muaw