5H 2 SEATS 4 Squeeze hooked end of seat adjuster locking 2 Remove hog rings securing central portion of wire together and slide retaining spring back over lower rear edge of seat back trim from front seat hump in locking wire and remove locking wire cushion spring assembly from adjuster 3 Raise trim and remove cardboard breakover 5 Remove adjuster to seat bottom frame front foundation to expose seat cushion spring attachment and rear attaching bolts and remove seat adjuster to seat back frame along rear of seat and hog rings from seat assembly Fig 5Hl securing ends of seat back trim to seat bottom frame See Fig 5H2 6 To install reverse removal procedure Check seat assembly for proper operation prior to in 4 At each end of seat remove hog rings securing stalling seat assembly lower edge of seat back trim from seat bottom frame Then raise seat back trim to expose bolts securing seat back reinforcement to seat bottom NOTE The right and left seat adjuster sliding frame See Fig SH3 mechanisms should be in same relative position when attaching adjuster to seat bottom frame 5 Bend open tabs securing seat cushion spring assembly to seat back frame and carefully dis engage springs from tabs See Fig 5H2 7 lf adjusters do not lock or unlock satisfac torily when control handle on left adjuster is 6 Place seat assembly in upright position Then operated disengage locking wire retainer from hole with a helper holding seat back assembly remove in seat bottom frame and engage retainer in one of seat back reinforcement to seat bottom frame at adjacent holes to obtain proper tension in wire taching bolts on each side of seat and remove seat Fig 5Hl back assembly T To install reverse removal procedure FRONT SEAT BACK ASSEMBLY NOTE Make certain rear edge of seat cushion Removal und l s Il i n spring assembly is properly engaged to seat back frame and cardboard breakover foundation is 1 Remove front seat assembly from body and properly positioned prior to hog ringing central place it upside down on a clean protected surface portion of trim in place